Homemade Lures For Bass Fishing

There are many advantages to making your own lures for bass fishing. Not only will you save a lot of money, but you can customize them in a thousand ways. Different parts are often combined to create a lure and using different colors, weights and sizes that match specific fishing situations, you can make lures that are specific to your fishing situation. Making lures for bass is a good way to make custom designs that can increase your catch, you never know until you try. With this article we will try to offer you five simple steps to make your own lures. Here is what you will need: making bait wire, pliers, inline spinner body, rubber spider skirt, beads, Buzz bait knife, rivet collars

.

Step 1 - stick to 8 inches long ordeal making wire with a couple of jaw needle nose pliers. This wire must be held to max 1 ¾ inches from the end of the wire. At the end of the wire, slide the hook. The final size of hook depends on personal preference and the buzz bait.

2 step - you now need to get the cable around the hook and needle clamp with the second pair of pliers in order to successfully form a loop. Now, you must withdraw without strings end up on the main wire and bend the free end around the main wire so that it will close the loop and hook to secure your place. Now is the time to remove the needle nose pliers.

Step 3 - it's time to slip rubber skirt on in-line spinner body and push it to the wire followed by one / two-color beads, if desired. In this way, it will add weight buzz bait casting and will help the bait to sit in the water at a time when it will reach.

4 step - take your wire and bend 2 ½ to 3 inches above the loop you made in the previous steps at the end of the wire. Take the pliers and use them to bend the wire down to form a ½ inch wide long in shape. You should measure ¾ inches down "U" shaped bend in the wire and bend the wire at a right angle.

Step 5 - Your last step is to measure about 1 cm and bend wire again using the pliers so that the wires are pointing downwards. Take a knife and rumors put it at the free end of the wire pointing down below the collar fasteners. You must ensure that the wide flat end of the rivets was along the blade. Now is the time to complete the buzz bait wire bending beneath the rivets, a right angle. Next, trim the wire so that it will extend no more than about ¼ inch from the bend below the rivets.

As you can see, the process of creating your very own home-made lures for bass fishing is not very difficult, you just have to be very careful and take things nice and slow. Read these steps over and over again until you do it right and some of his, save lots of money.